This article will explain how to calibrate the AUTOMATiQ, using the integrated FIT System.

When to conduct a calibration

Calibrating the automatic shifting interface is always needed after one of the following:

• After the initial assembly of the e-bike.
• When the automatic shifting hub interface (e.g. AUTOMATiQ) was removed for maintenance reasons.
• When the system does not work properly.

Calibration options

These are the many ways you can calibrate an AUTOMATiQ hub interface:

With a smartphone or tablet

• How to calibrate the new AUTOMATiQ using the enviolo App

With a CLiQ controller

• How to calibrate the AUTOMATiQ using the CLiQ controller

With the bike's integrated system

• How to calibrate the AUTOMATiQ using a BOSCH integrated display
• How to calibrate the AUTOMATiQ using the Bafang integrated display
• How to calibrate the AUTOMATiQ using the FIT integrated display
• How to calibrate the AUTOMATiQ using the Specialized integrated display

Step-by-step instructions

Video

Tools

• A bicycle with a FIT integrated system.

Calibration instructions

1. Turn on the e-bike with the FIT system.
2. Enter the setup menu using the joystick.
3. Select "Calibration" and confirm by pressing the joystick.
4. Select "Calibrate enviolo" and confirm by pressing the joystick.
5. Lift up the rear wheel and pedal fast and easy.
6. Start calibration by pressing the joystick again.
7. Pedal the e-bike lightly through the entire calibration process (preferably on a stand with the rear wheel off the ground), while the system shifts from full underdrive to full overdrive multiple times and completes the calibration process.
   • This process will take ~25 seconds.

Calibration done

Enjoy the ride! If you followed all the steps the e-bike is ready to go. If you have any questions, please reach out to our Support team.