This guide explains how to calibrate using the enviolo AUTOMATiQ. There are multiple ways that you may want to consider, but this guide will focus on helping how to calibrate the AUTOMATiQ using the enviolo App, which works with any bike setup. This is part of a series of 5 retrofit guides to install the new AUTOMATiQ.

Retrofit guides index

List of all AUTOMATiQ retrofit guides, part by part:

• Intro - Hub interface assembly options
  • Part 1.A - Assembly from Automatic+ or Harmony H|sync
  • Part 1.B - Assembly from Automatic or Harmony
  • Part 1.C - Assembly from Manual
• Part 2 - Rear wheel assembly
• Part 3 - AUTOMATiQ configuration
• Part 4 - AUTOMATiQ calibration
• Part 5 - Optional CLiQ controller assembly and pairing

Calibration options

These are the many ways you can calibrate an AUTOMATiQ hub interface:

With a smartphone or tablet

• How to calibrate the new AUTOMATiQ using the enviolo App

With a CLiQ controller

• How to calibrate the AUTOMATiQ using the CLiQ controller

With the bike's integrated system

• How to calibrate the AUTOMATiQ using a BOSCH integrated display
• How to calibrate the AUTOMATiQ using the Bafang integrated display
• How to calibrate the AUTOMATiQ using the FIT integrated display
• How to calibrate the AUTOMATiQ using the Specialized integrated display

To calibrate with the AUTOMATiQ App, continue below.

Step-by-step instructions

Video

Tools

• A mobile device with the enviolo AUTOMATiQ App installed:
  • Android 8 or higher - Download from Google Play Store
  • iOS 13 or higher - Download from Apple App Store

Calibration instructions

1. Open the enviolo AUTOMATiQ app on your smartphone.
2. Activate Bluetooth.
3. Turn on the e-bike drive system.
4. On the Devices List panel, tap on your AUTOMATiQ hub interface.
   • If you’re connecting to an AUTOMATiQ hub interface for the first time, then you need to pair it first. 
   • To activate pairing mode, press the white button on the AUTOMATiQ (A) for 3 seconds until it starts blinking blue. The AUTOMATiQ will then show in the Devices List.
     
5. Once you get to the main screen, the Settings panel, tap on CALIBRATE AUTOMATiQ.
6. Start the calibration, following the instructions on the screen:
   • You will need to pedal consistently for about 25 seconds.
   • Make sure the rear wheel can spin freely.
7. When done, a confirmation message will prompt.

Good job!

If you successfully followed all the retrofit guides up until this point, then good job! Your e-bike is ready to go. You can now enjoy the ride, or proceed to one last optional step.

Optional next step

As an option last step, you can assemble a CLiQ Pro controller.

Continue - Retrofit to the AUTOMATiQ - Part 5: Optional CLiQ Controller