This guide will walk you through how to calibrate the automatic shifting interface - the AUTOMATiQ -  using the CLiQ controller.

When to conduct a calibration

Calibrating the automatic shifting interface is always needed after one of the following:

• After the initial assembly of the e-bike.
• When the automatic shifting hub interface (e.g. AUTOMATiQ) was removed for maintenance reasons.
• When the system does not work properly.

Calibration options

These are the many ways you can calibrate an AUTOMATiQ hub interface:

With a smartphone or tablet

• How to calibrate the new AUTOMATiQ using the enviolo App

With a CLiQ controller

• How to calibrate the AUTOMATiQ using the CLiQ controller

With the bike's integrated system

• How to calibrate the AUTOMATiQ using a BOSCH integrated display
• How to calibrate the AUTOMATiQ using the Bafang integrated display
• How to calibrate the AUTOMATiQ using the FIT integrated display
• How to calibrate the AUTOMATiQ using the Specialized integrated display

Step-by-step instructions

There are 3 different CLiQ controllers. Follow the instructions for your model:

A - CLiQ Pro

Tools

• A bicycle with a CLiQ Pro already assembled and paired.

Calibration instructions

1. Turn the system power on.
2.  Select “no motor assist”.
3. On the controller, press and hold the MODE (1) and DOWN (3) buttons for 3 seconds until the rear hub begins shifting, and then release the button.
4. Pedal the bicycle lightly through the entire calibration procedure (preferably on a stand with the rear wheel off the ground), while the system shifts from “low” to “high” ratio multiple times and completes the calibration.
5. Once calibration is successful the controller lights continuously green for 5 seconds.
   • In case the calibration is unsuccessful, the controller lights continuously red for 10 seconds. If so, please retry the calibration.
   • Calibration shall not take longer than 20 seconds.

B - CLiQ Plus

Tools

• A bicycle with a CLiQ Plus already assembled and paired.

Calibration instructions

1. Turn the system power on.
2.  Select “no motor assist”.
3. On the enviolo CA controller (1), press and hold the up and down button simultaneously for 3 seconds until the rear hub begins shifting, and then release the button. While the calibration is active, the LED will flash white.
4. Pedal the bicycle lightly through the entire calibration procedure (preferably on a stand with the rear wheel off the ground), while the system shifts from “low” to “high” ratio multiple times and completes the calibration.
5. Once calibration is successful the CA controller lights continuously blue for 5 seconds.
   • In case the calibration is unsuccessful the CA controller lights continuously red for 5 seconds. If so, please retry the calibration.
   • Calibration shall not take longer than 20 seconds.

C - CLiQ Pure

Tools

• A bicycle with a CLiQ Pure already assembled and paired.

Calibration instructions

1. Turn the system power on.
2. Select “no motor assist”.
3. Pedal the bicycle lightly through the entire calibration process (preferably on a stand with the rear wheel off the ground).
4. On the controller (1), press and hold the center button for 3 seconds until the rear hub begins shifting, and then release the button.
5. Continue to pedal lightly through the entire calibration procedure, while the system shifts from “low” to “high” ratio multiple times and completes the calibration.
   • Calibration shall not take longer than 20 seconds.

Calibration done

Enjoy the ride! If you followed all the steps the e-bike is ready to go. If you have any questions, feel free to reach out to our Support team.