This article will explain how to properly calibrate an enviolo AUTOMATiQ system via the enviolo AUTOMATiQ app.

When to conduct a calibration

After one of the following:

• After the initial assembly of the e-bike.
• When the AUTOMATiQ hub interface was removed for maintenance reasons.
• When the system does not work properly.

Calibration options

These are the many ways you can calibrate an AUTOMATiQ hub interface:

With a smartphone or tablet

• How to calibrate the new AUTOMATiQ using the enviolo App

With a CLiQ controller

• How to calibrate the AUTOMATiQ using the CLiQ controller

With the bike's integrated system

• How to calibrate the AUTOMATiQ using a BOSCH integrated display
• How to calibrate the AUTOMATiQ using the Bafang integrated display
• How to calibrate the AUTOMATiQ using the FIT integrated display
• How to calibrate the AUTOMATiQ using the Specialized integrated display

Video instructions

Step-by-step instructions

Video

Tools

• A mobile device with the enviolo AUTOMATiQ App installed:
  • Android 8 or higher - Download from Google Play Store
  • iOS 13 or higher - Download from Apple App Store

Calibration instructions

1. Open the enviolo AUTOMATiQ app on your smartphone.
2. Activate Bluetooth.
3. Turn on the e-bike drive system.
4. On the Devices List panel, tap on your AUTOMATiQ hub interface.
   • If you’re connecting to an AUTOMATiQ hub interface for the first time, then you need to pair it first. 
   • To activate pairing mode, press the white button on the AUTOMATiQ (A) for 3 seconds until it starts blinking blue. The AUTOMATiQ will then show in the Devices List.
     
5. Once you get to the main screen, the Settings panel, tap on CALIBRATE AUTOMATiQ.
6. Start the calibration, following the instructions on the screen:
   • You will need to pedal consistently for about 25 seconds.
   • Make sure the rear wheel can spin freely.
7. When done, a confirmation message will prompt.

Calibration is done

If you follow all the steps the e-bike is ready to go. Enjoy the ride!