• Install cable end hardware only by pulling cables at the end of the housing. Never rotate the grip with cables unattached, as they can bind inside the barrel adjuster.
• Pass the shift cables through the appropriate cable housing and ensure the housing is seated completely into the shifter.
• Thread both barrel adjusters completely clockwise (in) to provide maximum installation slack.
• Pull the underdrive shift cable, marked green or black, firmly at the rear axle location until it stops, checking to make sure that the shift indicator [N] goes completely flat (enviolo TR and SP controllers), or that the grip rotates fully in the counter-clockwise direction shown (enviolo CT, CA and CO shifter,
viewed from the right side of the bicycle).

mceclip0.png
• Pass the underdrive shift cable through the UD cable stop [O&P] and secure the UD cable stop at the distance shown [O&P] while pulling the cable firmly.

mceclip1.png

mceclip2.png
• Ensure that the cable housing is seated fully at the barrel adjuster.
• Using a 2mm allen, secure the cable and torque to 1.5-2.0 Nm (13-18 in-lbs).

• Cut the excess cable as short as possible, at a maximum of 2.0mm from the end of the UD cable stop [Q].

mceclip1.png
• Pull the overdrive shift cable firmly at the manual hubinterface until it stops, checking to make sure that the shift indicator [Q] goes into a steep hill (enviolo TR and SP shifters), or that the grip rotates fully in the clockwise direction shown (enviolo CT, CA, CO shifters, viewed from right side of bicycle).
• Make sure the underdrive shift cable and UD cable stop are free and unobstructed
• Pass the overdrive shift cable through the OD Latch [R] and secure the OD latch at the distance shown [S] while pulling the cable firmly.

mceclip2.png

mceclip3.png
• Ensure that the cable housing is seated fully at the shifter.
• Using a 2mm allen, secure the cable and torque to 1.5-2.0 Nm (13-18 in-lbs).
• Cut the excess cable at the OD latch marking, and tuck the remaining cable length into the OD latch.
• The cable hardware should appear as shown.

Was this article helpful?
0 out of 0 found this helpful