1. Switch eBike power “off” and disconnect the eBike battery (if possible).
2. [C] Remove the AUTOMATiQ main connector at the rear wheel
Grab the connector at the connector (A) and pull lightly away from the AUTOMATiQ Hub Interface/
the frame.
mceclip0.png
3a. For the variants enviolo CT/TR/CO/CA:
[D] Loosen and/or remove the axle nuts (A), followed by the no turn washers.

mceclip1.png
For rim and roller applications follow the manufacturer´s instructions.
3b. For the variants enviolo SP:
1. 135mm variants: Loosen and remove the axle nuts and washers.


For rim brake applications follow the manufacturer´s instructions.
2. 142/148mm variants: Loosen and remove the axle bolts and left side adapter.


For rim brake applications follow the manufacturer´s instructions.
4. [E] Remove the rear wheel
Some eBikes may require rotating the hub axle and AUTOMATiQ Hub Interface to allow removal of
the bicycle chain. In some cases, it is easiest to remove the chain from the front chainring to ease
the rear wheel removal.

mceclip2.png

Note: Do not pull on the cable, only at the ribbed connector hall as shown.

Note: The connector supplies electrical power to the AUTOMATiQ Hub Interface. Protect the connector
from water or other conductive elements when disconnected, as shock or damage to the system could
result.

 

Was this article helpful?
0 out of 0 found this helpful