INSTALLING THE ENVIOLO CA CONTROLLER
• Install the right brake lever and gripaccording to the manufacturer’s instruction.
• Push the controller bracket over the 22.2mm handlebar. Use the adapter ring if installing.
• Position the controller such that the buttons are positioned slightly under the handlebar and comfortable for thumb controls.
• Tighten the controller clamp to 1.5-2.0Nm with a 2.5mm allen wrench.

mceclip0.png

INSTALLING THE ENVIOLO CO CONTROLLER
• Install the right hand grip onto the handlebar according to the manufacturer’s instructions.
• Slide the clamp over the handlebar and tighten it to 1.0-2.0Nm with a 3mm Allen wrench.
• Position the controller such that the button can be easily reached with the thumb, while riding.
• The enviolo CO controller can be mounted to either right or left side of the handlebar.

mceclip1.png

For the enviolo CO controller, also note:
Assembly on the left side of the handlebar

After you have installed the enviolo CO on the left side, please press and hold the upper and middle buttons (and) for about 2 seconds. Once the Status LED turns green for 2 seconds, the remote control is set to the left side of the handlebar.

Assembly on the right side of the handlebar
After you have installed the enviolo CO on the right side, please press and hold the upper and middle buttons (and) for about 2 seconds. Once the Status LED turns red for 2 seconds, the remote control is set to the right side of the handlebar.

 

The battery of the controllers can be changed without special knowledge and by using a 50 euro cent coin. For this purpose, a standard CR2032 battery is required, which is inserted into the new remote control.

Was this article helpful?
0 out of 0 found this helpful