This video will show you how to reset the full underdrive position on Cargo & Sportive Hubs.

 TECHNICAL INSTRUCTION:

1. Install the enviolo hub into a vice or similar fixture
2. Remove the shift retainer from the hub
3. Place the shift driver tool on to the shift driver
4. Rotate the hub and shift driver tool clockwise
5. Continue until you hit a hard stop or are unable to rotate anymore with the shift driver tool
6. Remove the shift driver tool
7. Rotate the hub interface fully clockwise
8. Place the hub interface onto the hub
9. Rotate the hub slightly & place the end of the tool into the position, giving a 25mm offset
10. Remove the hub interface from the hub and return it to full clockwise positioning
11. Place the hub interface back on to the hub
12. While rotating the hub clockwise, rotate the interface counterclockwise into full overdrive position
13. You can now proceed with the regular installation process

Was this article helpful?
3 out of 3 found this helpful