To simplify the assembly process we have created step-by-step work instructions for all AUTOMATiQ components.
All assembly steps include an overview of parts and tools needed as well as a link to a video explanation.

 

Installing the magnet rings

Video

1. Mount the sprocket onto the hub

1.png

2. Mount the sprocket magnet ring (AUT-ISS-OE) on top of the snap ring

2.png

3. The opening of the magnet ring and snap ring must be aligned

3.png

4. Ensure the OSS2 has a yellow serial # sticker 

4.png

5. Install the hub magnet ring (AUT-OSS2-OE) onto the hub flange

5.png

6. Tighten it to 1Nm with a 2.5mm Allen wrench

6.png

Installing the AUTOMATiQ Hub Interface

Videos: Mounting the AHI / Mounting the rear wheel 

1. Push the AHI (AHI-XX-OE) onto the axle and tighten  the lock nut (HW-HNUT-OE)  with a torque wrench and long 17mm socket to 10-15Nm

7.png

2. Insert the wheel into the dropout and make sure the sensor does not interfere

8.png

3. Slide the no-turn washers (HW-WASH-OE) into the dropout and tighten the acorn nuts  (HW-ANUT-OE) with a torque wrench with a 15mm long socket to ~30-40Nm

9.png

4. Make sure the connector on the AHI is unobstructed

10.png

5. Ensure you have the power supply from the drive system available via proprietary cable or our solution (WIRE-AT3-DS-OE)

11.png

6. Connect the wire harness (WIRE-AT3-400-OE or WIRE-AT3-600-OE) to the AHI and the drive system side.

12.png

Create the QR code

Video 

1. Login to https://automatiq.enviolo.com/

13.png

2. Go to “Management” -> “Brand”

14.png

3. Select all desired configurations and click “save changes”, then select the blue QR code symbol on the right

15.png

4. You will now see the QR code and all information and can print it for your assembly line

16.png

How to configure the AHI

Videos: Pairing / Programming with QR Code / AUTOMATiQ configuration with the App 

1. With the drive system on, push and hold the indicated button on the AHI for 5 seconds until it starts blinking  blue

20.png

2. Open the enviolo app on your phone or tablet and select the desired device 

19.png

3. The serial # of the hub interface can be found on the bottom of the hub interface

18.png

4. Go to the configuration menu, scroll down and select “Scan QR code”

17.png

Calibrate the system

Videos: App / Intuvia / Kiox 

1. In the configuration menu, scroll down and trigger the calibration by selecting “recalibrate the hub interface”

21.png

2. Follow display specific instructions

23.png22.png

3. After triggering the calibration you have to pedal constantly and lightly for 7-10 seconds for all variants until the system shifts 2-3 times through the full ratio range

 

 

Was this article helpful?
0 out of 0 found this helpful