In the past, there were two versions of the manual hub interface (MHI), other than the difference in 40T or 44T spline nuts. These two versions were differentiated as follows:
Multi-turn | One-turn | |
---|---|---|
Shifting force | Lighter shift action | Heavier shift action |
Twisting length | Longer twist | Shorter twist |
Spline nut | 40T or 44T | 40T or 44T |
We recommend multi-turn MHI
The one-turn interface is a legacy MHI and is no longer produced. enviolo only produces multi-turn MHIs, which makes manual shifting more effortless by comparison. You can buy a multi-turn MHI from our orders platform.
Multi-turn MHI
With a small internal gearing for lighter shift action and great fine-tuning abilities, in exchange for more grip rotation required to shift through the hubs' ratio range.
To shift the full ratio range of the hub these interfaces will make a full rotation from H to L position. With these interfaces, the controller display will also move from completely flat to showing a mountain:
Overdrive (H) |
Underdrive (L) |
One-turn MHI
This is a “direct drive” interface, for faster shift action (less rotation), with a downside of heavier operation and harder to fine-tune.
These interfaces will shift through the complete ratio range with less rotation moving from H to the approximate below position. The controller will also not use its complete range and move only from flat to show a hill:
Overdrive (H) |
Underdrive (L) |