Never rotate the grip with cables unattached, as they can bind inside the controller.

  • Thread both barrel adjusters completely clockwise (in) to provide maximum installation slack.
  • Pull the underdrive shift cable, marked green or black, firmly at the rear axle location until it stops, checking to make sure that the shift indicator [N] goes completely flat (enviolo TR and SP controllers), or that the grip rotates fully in the counter-clockwise direction shown (enviolo CT, CA and CO controller, viewed from the right side of the bicycle).

mceclip0.png

  • Pass the underdrive shift cable through the UD cable stop [O&P] and secure the
    UD cable stop at the distance shown [O&P] while pulling the cable firmly.
  • Ensure that the cable housing is seated fully at the controller.
  • Using a 2mm allen, secure the cable and torque to 1.5-2.0 Nm (13-18 in-lbs).
  • Cut the excess cable at a maximum of 2mm from the end of the UD cable stop [P].

mceclip1.png

mceclip2.png

  • Pull the overdrive shift cable firmly at the manual hub interface until it stops,
    checking to make sure that the shift indicator [Q] goes into a steep hill
    (enviolo TR and SP controllers), or that the grip rotates fully in the clockwise
    direction shown (enviolo CT, CA, CO controllers, viewed from right side of
    bicycle).

mceclip3.png

  • Ensure that the cable housing is seated fully at the controller.
  • Pass the overdrive shift cable through the OD Latch [R] and secure the OD
    latch at the distance shown [S] while pulling the cable firmly.
  • Using a 2mm allen, secure the cable and torque to 1.5-2.0 Nm (13-18 in-lbs).
  • Cut the excess cable at the OD latch marking, and tuck the remaining cable
    length into the OD latch.

mceclip4.png

Was this article helpful?
1 out of 2 found this helpful