Carefully rotate the grip with cables unattached, as they can bind inside the controller.
- Thread both barrel adjusters completely clockwise (in) to provide maximum installation slack.
- Pull the underdrive shift cable, marked green or black, firmly at the rear axle location until it stops, checking to make sure that the shift indicator [N] goes completely flat (enviolo TR and SP controllers), or that the grip rotates fully in the counter-clockwise direction shown (enviolo CT, CA and CO controller, viewed from the right side of the bicycle).
- Pass the underdrive shift cable through the UD cable stop [O&P] and secure the
underdrive cable stop at the distance shown [O&P] while pulling the cable firmly. - Ensure that the cable housing is seated fully at the controller.
- Using a 2mm allen, secure the cable and torque to 1.5-2.0 Nm (13-18 in-lbs).
- Cut the excess cable at a maximum of 2mm from the end of the underdrive cable stop [P].
- Pull the overdrive shift cable firmly at the manual hub interface until it stops,
checking to make sure that the shift indicator [Q] goes into a steep hill
(enviolo TR and SP controllers), or that the grip rotates fully in the clockwise
direction shown (enviolo CT, CA, CO controllers, viewed from right side of
bicycle).
- Ensure that the cable housing is seated fully at the controller.
- Pass the overdrive shift cable through the overdrive Latch [R] and secure the overdrive
latch at the distance shown [S] while pulling the cable firmly. - Using a 2mm allen, secure the cable and torque to 1.5-2.0 Nm (13-18 in-lbs).
- Cut the excess cable at the overdrive latch marking, and tuck the remaining cable
length into the overdrive latch.