PROBLEM: SHIFT FORCES ARE TOO HIGH

 

WHICH STEPS CAN SOLVE THIS

 

  1. The shift cables do not have the correct length
  2. The shift cables are not set correctly and have too much or too little play (0.5-2mm)
  3. The shift cable housing is not ideal and has too much resistance - Switch to Jagwire
  4. The cable routing inside the frame has too many tight bends
  5. The manual hub interface is a one-turn interface and you can improve the shift force by switching to a multi-turn
  6. The system can only shift ~50% during stand still
  7. Shift forces are higher under load
Was this article helpful?
0 out of 1 found this helpful