Assembly documentation

Follow
AUTOMATiQ assembly instructions
Resetting the full underdrive position on enviolo hubs
AUTOMATiQ ride profiles
enviolo AUTOMATiQ firmware release notes
Calibration with AUTOMATiQ controllers
Pairing the AUTOMATiQ controller
Installing enviolo AUTOMATiQ controllers
Installing the Automatic controllers
Calibration of AUTOMATiQ integrated systems (Bosch & Flyer)
Installing the rear wheel for AUTOMATiQ variants
Installation of the AUTOMATiQ hub interface
Installing the AUTOMATiQ Magnet rings
Adjusting cable slack
Installing the rear wheel for manual systems
Setting the cable length with the cable cutting tool
Installation of shift cable housing
Installation of manual controllers
Installation of manual hub interface
Installation of sprockets
Wheel building
Logistics data sheet MY2019
Assembly instruction MY2021
Setting Manual Cable Length