The LED on AUTOMATiQ hub interface is showing magnet rings detection, calibration feedback and connectivity information. A list of LED behavior will help with troubleshooting and setting the AHI.
NOTE: The LED on AUTOMATiQ hub interface turns off if wheel speed is higher than 5km/h.
LED colour explanation
| Function | LED color | State |
|---|---|---|
| Wheel speed higher than 5km/h | OFF | LED is turned off |
| Bluetooth pairing active | Blue | Toggling every 1s |
| Bluetooth pairing failed | Red | ON for 3 seconds |
| Bluetooth pairing success | Green | ON for 3 seconds |
| Bluetooth connected | Blue | ON continuously |
| Command received (Bluetooth or CAN) | Green | ON for 0.2s every 2s |
| Calibration required | Red Green | Alternating every 1s |
| During calibration | Red Green | Alternating every 1s |
| Input speed ring pulse detected | Green | ON for 0.2 seconds |
| Output speed ring pulse detected | Red | ON for 0.2 seconds |
Further help
If you still have any questions, don't hesitate to contact support.