This guide will explain how to properly replace shifter cables on enviolo manual controllers.

Controllers factory cable length

Our controllers are delivered with 1.1 or 1.2 mm shift cables.

Step-by-step instructions

Video

Tools

• Small Philips screwdriver
• Small Flat screwdriver

Disassembly instructions

Remove the cable end hardware from both cables and remove the shift cables from the controller housing.

1. Remove the Phillips screw on the bottom of the manual controller and remove the bottom cover by pulling lightly on the access tab.
   
2. Pull the cables outside of the housing as far as possible.
   • In this way, you can try to fold and push using a small flat screwdriver or pointed object, extract the cable anchors, and shift cables from the grip pulley.
   • Rotate the grip to access individual cable anchors.
     

Assembly instructions

Reassemble new cables, one by one:

1. Install one shift cable, allowing the controller housing to guide the cable around the internals until it comes out on the other side.
   • Guide the cable through the closest barrel adjuster.
     
2. Pull the cable through the barrel adjuster until the cable anchor seats fully into the grip pulley.
   
3. Rotate the grip to position the next cable for installation, and repeat steps 1 and 2.
4. Reinstall the bottom cover and torque it to 0.2-0.3 Nm.

Done

If you have any questions don't hesitate to reach out to enviolo support.