This guide explains how to assemble a rear wheel with a Manual hub interface and solid axle hub onto a 135mm bike frame.
Backward compatibility
This guide is compatible with legacy enviolo and NuVinci 135mm solid axle hubs.
Exercise caution when assembling the no-turn washers
Improper installation of the no-turn washers may result in damage to the dropout and the hub. Over-tightening may damage parts. Under-tightening can result in the axle sliding in the dropouts.
Step-by-step instructions
Video
Tools
- 15mm wrench
- Torque wrench
- 15mm long socket
- 17mm long socket (only for Extreme hub)
Assembly instructions
- Guide the belt or the chain onto the sprocket and place the rear wheel into the rear frame.
- Make sure not to obstruct shift cables.
- Slide the non-turn washers (A) onto each axle side.
- The serrations of the non-turn washer must bear against the dropout of the frame.
- The rectangular boss must engage in the dropout of the frame.
- Mount the axle nuts (B) onto each axle side.
- Tighten them to 30-40Nm.
- Assemble the cable end hardware onto the interface. To perform this last step, a controller must already be assembled with the right cable length. See these guides:
Next steps
If you follow the steps above, your wheel is now assembled on the bike. Once you assemble a shifter with the right cable length as well, your bike will be ready to go.