See how to properly assemble and pair the CliQ Plus controller.

Step-by-step instructions

We recommend assembling on the right side of the handlebar

The CliQ Plus controller can be mounted on either side of the handlebar. In general, we recommend mounting on the right.

1 - Assemble the controller

Tools

• 2.5mm Allen wrench

Assembly instructions

1. Assemble the right brake lever and grip according to the manufacturer’s instructions.
2. Push the controller bracket over the handlebar.
   1. Use the adapter ring if installing.
3. Position the controller such that the buttons are positioned slightly under the handlebar and comfortable for thumb controls.
4. Tighten the controller clamp to 1.5 - 2Nm with a 2.5mm Allen wrench.

2 - Pair the controller

Pairing instructions

1. Power on your drive system.
2. On the Automatic interface, push and hold the white button for ~3 seconds until it starts blinking blue, indicating that the interface is in pairing mode.
3. Turn on the controller, and press and hold the power button (A) until it starts blinking a blue LED, indicating that the controller is in pairing mode.
   • If the controller doesn't turn on and needs a battery, use a 2.5mm Allen wrench and a coin to access the inside and insert a CR2032 battery.
4. The CliQ Plus should now pair with the Automatic interface.
   • When the controller LED goes dark, then it's paired.
   • You can also confirm the connection if a white LED shows when pressing any of the cadence shift buttons (B)(C)(D)(E).
   • If the controller LED is still blinking, then it's not connected and still searching for a connection.

Battery

The CliQ Plus uses a standard CR2032 battery. The battery can be changed by using a 2.5mm Allen wrench and a €0,50 coin.