This article will explain how to properly assemble an enviolo manual controller on a bicycle handlebar.

Video instructions

Step-by-Step instruction

Tools

• 3mm Allen key

Assembly instructions

1. Install the right brake lever according to the manufacturer’s instructions.
2. Slide the controller onto the handlebar.
   
3. Install the right hand grip onto the handlebar according to the manufacturer’s instructions.
   
4. Position the controller such that the display is visible to the rider and the cable will be unobstructed.
5. Barrel adjusters can be used for optimization of cable slack (0.5-1mm).
6. Tighten the clamp bolt to 2.0-2.5 Nm with the Allen key.

Keep some space between the shifter and rubber grip

Make sure that the controller rotates easily. The controller should not be tightly mounted against the grip. Leave a bit of space between the controller and the handlebar grip.

Danger

Never ride without the handlebar grip. The rubber part of the controller could become loose, which could result in a severe injury.