This retrofit guide explains how to properly assemble an optional CliQ Pro controller and pair it with your newly assembled Enviolo Automatic interface. This is part of a series of 5 retrofit guides to install the new Enviolo Automatic.

Retrofit guides index

List of all Enviolo Automatic (AutomatiQ) retrofit guides, part by part:

• Intro - Hub interface assembly options
  • Part 1.A - Assembly from Automatic+ or Harmony H|sync
  • Part 1.B - Assembly from Automatic or Harmony
  • Part 1.C - Assembly from Manual
• Part 2 - Rear wheel assembly
• Part 3 - Configuration
• Part 4 - Calibration
• Part 5 - CliQ controller (optional)

Step-by-step instructions

1 - Assemble the controller

Tools

• Torx T20 wrench

Assembly instructions

1. Assemble the right-hand grip and brake lever onto the handlebar according to the manufacturer’s instructions.
2. Slide the clamp over the handlebar.
3. Position the controller such that the button is positioned slightly under and comfortable for thumb controls.
   • The enviolo CLiQ Pro controller can be mounted to either the right or left side of the handlebar.
4.  Tighten it to 1 Nm with a Torx T20.

2 - Pair the controller

Video

Pairing instructions

1. Power on your drive system.
2. On the Automatic interface, push and hold the white button for ~3 seconds until it starts blinking blue, indicating that the interface is in pairing mode.
3. Turn on the controller, and press and hold the power button (C) until it starts blinking a blue LED, indicating that the controller is in pairing mode.
   • If the controller doesn't turn on and needs a battery, use a coin and insert a CR1/3N.
4. The CliQ Pro should now pair with the Automatic interface.
   • When the controller LED goes dark, then it's paired.
   • You can also confirm the connection if a white LED shows when pressing up (B) or down (D).
   • If the controller LED is still blinking, then it's not connected and still searching for a connection.

Battery

The CliQ Pro uses a standard CR1/3N battery. The battery of the controllers can be changed simply by using a coin.

Using the controller

With a newly assembled CliQ controller, you can change the cadence on your Enviolo Automatic on the go.

Operation modes

You can change between AUTO and MANUAL shifting via the Enviolo app.

• AUTO – the Enviolo Automatic will intelligently adjust the cadence to the ride. This sets the CliQ controller, or integrated system (e.g. BOSCH), to adjust the preferred cadence.
• MANUAL – the Enviolo Automatic interface will emulate a 9-speed gear hub. This sets the CliQ controller, or integrated system, to change cadence manually by emulating 9 gears. 

Download the Enviolo app

• Android 8 or higher - Download from Google Play Store
• iOS 13 or higher - Download from Apple App Store

To learn more about how to use the Enviolo app, read read this article.

The Enviolo Automatic works best in AUTO mode

The Enviolo Automatic is an intelligent set-and-forget system – simply set your preferred cadence (pedalling pace), and the interface automatically adjusts to the rider's conditions. When you set the Enviolo Automatic to AUTO mode, you can use the CliQ controller to adjust the preferred cadence.